Species Management and Control Information

Poison hemlock
Conium maculatum L.

Source: The following information is taken from a number of sources and those sources are identified at the beginning of the referenced information. The intent of this resource is to provide the user with as much of the information that exists for management and control of this species as is practical. It is important to note that new and improved methods are added regularly which will require you to visit the websites provided for updates on this information. Bibliographies and resources referenced by these sources are not included here, but are included at the websites from which this information was extracted.

READ THIS FIRST! Before administering any of the following management and control options, it is imperative that you are familiar with the background information provided under the General Management and Control Section. For additional, and potentially more current, information on management and control of this species, use the Mid-Atlantic Exotic Pest Plant Council (MA-EPPC) listserve or any of the other listserves identified in the Resource - Listserve section of this tutorial. You will find directions for subscribing to the list serve there. The MA-EPPC listserve has an archives feature that saves past discussions (beginning in 1999) about specific species control. These messages are at: http://groups.yahoo.com/group/ma-eppc/messages.

All information that follows in taken from the following resource:

The Nature Conservancy - Invasive Species Initiative - Species Management Summary (ESA or Element Stewardship Abstract): Conium maculatum - http://tncweeds.ucdavis.edu/esadocs/conimacu.html - Author: Don Pitcher - May 31, 1989.

GENERAL MANAGEMENT CONSIDERATIONS:

Mechanical or chemical removal of Conium maculatum is relatively easy (see Management section below), but complete eradication may be difficult due to reintroductions and the presence of viable seeds in the soil.

Conium maculatum requires active control measures or it can become dominant on a site, particularly disturbed areas such as roadsides.

Most of the following management information was obtained through personal communication with Jim McHenry, U.C. Davis Agricultural Extension (1985).

MANUAL AND MECHANICAL CONTROL:

Hand Pulling or Grubbing: Hand pulling works easiest with wet soils and with small infestations. When grubbing, it is not necessary to remove the entire root system since the plant is not perennial. It is best to pull or grub out the plant prior to flowering (Parsons 1973). "Follow-up cultivation is necessary to deal with any seedlings and if possible a vigorous pasture should be established to compete with any further seedling growth" (Parsons 1973). Poison hemlock remains toxic for several years after being pulled, and it is wise not to leave the dead plants where they might be eaten by wildlife or children.

Mowing: Multiple mowings close to the ground may eventually kill Conium maculatum. "Mowing or slashing of the plants just before flowering is often effective, but sometimes new growth which requires re-treatment is produced from the base" (Parsons 1973).

BIOCONTROL:

There are no known methods of effective biological control of Conium maculatum. The methods of using viral infection and/or phytophagous insects to control this weed need more research and experimentation.

Conium maculatum is often found infected by one or more strains of virus such as ringspot virus, carrot thin leaf virus (CTLV), alfalfa mosaic virus (AMV), and celery mosaic virus (CeMV) (Freitag and Severin 1945, Howell and Mink 1981). However, the stands of poison hemlock seem to survive in spite of viral attack. It is generally common for virus-affected plants to be more often stunted than killed. An apparent example of this phenomenon is the presence of extremely high populations of the ringspot vector, the honeysuckle aphid Rhopalosiphum conii (Dvd.), occurring on Conium.

Conium "is the only plant known to be infected by ringspot in nature. The two symptoms most useful in identifying this ringspot have been the chlorotic areas and the line patterns. They can easily be detected by the mottling of the leaves and by line and ringspot patterns. Under natural conditions the infected plants are not stunted, but often show a downward curling of the leaflets along the midrib" (Freitag and Severin 1945).

Similarly, populations of CTLV, AMV, and CeMV were isolated from Conium maculatum during a survey in southeastern Washington in 1975 and 1979. "CTLV and CeMV were the most prevalent viruses in wild carrot and poison hemlock of southeastern Washington. CTLV and CEMV were each recovered from 9% of the wild carrots and from slightly more than 20% of the poison hemlock, with 7% and 11% infected by both CTLV and CeMV, respectively ... AMV was found only at one location, infecting four poison hemlock plants" (Howell and Mink 1981).

"The incidence of CTLV and CeMV ranged from 0 to more than 80 percent. This variation appeared related to moisture availability. Where water was short through the summer, many of the second-year biennials matured and died before new plants emerged, thus decreasing the probability of virus transmission from the older to the younger weeds ... Poison hemlock, which is abundant in southeastern Washington, is considered a natural reservoir for CeMV in England (Pemberton and Frost 1974) and California (Sutabutra and Campbell 1971)" (Howell and Mink 1981).

However, as in the ringspot virus example cited above, use of these viruses as Conium maculatum controlling agents would depend upon (1) how they affect the viability of poison hemlock and (2) the feasibility of using an agent in the wild that could also adversely affect agricultural crops.

The useability of phytophagous insects to control Conium maculatum needs more experimentation. The phytophagous insect fauna of poison hemlock in southern California is largely comprised of relatively unspecialized, polyphagous, ectophagous, sap- and foliage-feeding species. Thereof, poison hemlock hosted amazingly few insect species or individuals. A clear majority, 16 of the 20 phytophagous insect species found on this weed, were rare.

"Substantial, but unquantified seed destruction by Hyadaphis foeniculi was noted at several locations, but otherwise poison hemlock suffered little insect injury. Most parts of this weed remain essentially free of deleterious insect attack. Apparently, the century since this weed was accidentally introduced into California (Robbins 1940) has provided sufficient opportunity for only very few native phytophagous insects to overcome its toxic defenses and transfer to this colonizing plant species" (Goeden and Ricker 1982).

"The larval 'anise swallowtail' usually feeds on Umbelliferae. This butterfly may be in the process of adopting poison hemlock as an additional food plant in California ... Foreign exploration for natural enemies of poison hemlock in Europe, especially in areas of Mediterranean climate for use in California, is indicated as the next step in ascertaining whether the relative trophic vacuum that this weed represents might be usefully filled by a complex of intentionally introduced, specialized natural enemies" (Goeden and Ricker 1982).

CHEMICAL CONTROL*:

If extensive areas are covered with Conium maculatum, chemical controls are simpler and less labor intensive.

2,4-D in moderate doses does not kill grasses (except the more susceptible bentgrass). It is most effective against poison hemlock when the ester form is mixed with diesel oil to allow penetration of the leaves and stems. It can be used to hand spot (the most effective technique), or to spray larger areas. The suggested mixture is 1.5 lbs acid equivalent per acre. Mix 2 quarts of diesel oil with 1.5 lbs of 2,4-D ester and add to 100 gallons of water in a spray tank. A 100-gallon tank should cover approximately one acre.

Banvel (active ingredient Dicamba) also works on broad-leaved plants but not as effectively as 2,4-D. The suggested mixture is 1/2 to 3/4 per 100 gallons of water and a surfactant is required.

* Mention of pesticide products in this document does not constitute endorsement of any particular material.